If you’re tackling a new toilet installed in your home, there are a few things that you should keep in mind. Most toilets don’t come as one unit and will require a tank-to-bowl gasket. Once the tank is installed in the toilet bowl, the bolts that hold the tank to the toilet should be tightened. If the bolts don’t turn easily, you may end up cracking the toilet. Fortunately, there are some common mistakes that you can make during this step.
First, make sure that the flange of your toilet is at least three inches higher than the finished floor. If the subfloor is very soft, the flange screws will not stay put. For this, you’ll need to install wax rings on the base of the toilet, but it’s easy to screw them in. You can buy a ring that fits snugly around the drain horn on the underside of the toilet.
If the flange is loosened, you’ll need to use ear-type repair rings to secure it. These ear-shaped pieces of wood allow you to drive a screw into firmer wood that’s further away from the flange. You’ll need to remove the ears if the rot extends beyond the flange, or you’ll have to replace the subfloor entirely. In this case, a plumber will be able to provide you with a free quote for the work.
The next step is to secure the toilet flange in the floor. The flange should be about half an inch higher than the finished floor. In addition, if you’re adding new flooring to the bathroom, it may be too low. In this case, you can install taller wax rings. There are also some that are wax-free and made from foam or rubber. Once all of these steps are completed, you can test the toilet to ensure it doesn’t leak.
After installing the toilet, you need to install the closet flange. You’ll need to screw the flange into the floor with a screwdriver. The screws that attach the closet collar should also be tightened. The flange must be higher than the finished floor. This is important to avoid the risk of the pipe slipping and falling. If the rot is above the trough, you need to replace the subfloor and the hole should be about four inches in diameter.
After installing the flange, you need to screw the toilet flange into the floor. It is necessary to screw the flange into the floor to keep the water from spilling. It is important to remember that the flange needs to be a little higher than the finished floor in order to prevent the water from leaking. If the flange is too low, then you can also use a taller flange.
Before you begin with the toilet installation, you need to make sure the existing flange is level. You should also ensure that the flange is slightly higher than the finished floor. In some cases, the flange can be too low when you’re installing a new floor. Fortunately, there are several methods for installing a toilet in your home. Before you start, get at least three quotes for the job. If you’re worried about the cost, you can opt for a more affordable option.
After you’ve removed the old toilet, you should install the new one. Then, you should install the flange in the new toilet. The flange is the part that holds the toilet. It should be slightly higher than the finished floor. However, if the flange is too low, you’ll need to buy a different nut. Once you’ve installed the new toilet, you should check for leaks and tighten the bolts.
Toilet installation involves removing the old toilet. You should be careful not to damage the flange while replacing it. After all, this task is complicated and often requires a lot of time and skill. But if you do this job right, it should be relatively easy to install a new toilet in your home. It will not take much time and effort. A professional plumber will be able to give you a warranty for the work he or she has done.
